HP Designjet 5000 Service Manual - Page 114
Turn DRIVE ROLLER, In the Service Utilities submenu, scroll to Turn DRIVE ROLLER
View all HP Designjet 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Service Tests and Utilities Turn DRIVE ROLLER PHONE SUPPORT The purpose of this Service Utility is to rotate the Overdrive, Drive Roller and Roller Mark in order to clean them. NOTE Remove the media before performing this operation. If media is detected, the message below is displayed. 1.1 Turn DRIVE ROLLER Please remove media completely Press ENTER to continue Perform the Turn DRIVE ROLLER utility as follows: 1. Lift the Window on the printer and deactivate the Window Sensor by inserting a pencil in the Sensor slot on the top of the Right Trim. 2. In the Service Utilities submenu, scroll to "Turn DRIVE ROLLER" and press Enter. 1. Service Utilities 1.1 Turn DRIVE ROLLER 1.2 Prime TUBES 1.3 Altitude Setup 1.4 EEROM Setup 1.5 Reset Life Counters 1.6 Backup EEROM Top Back ↑ Make Selection ↓ Enter Press Enter 3. Once the utility starts, the Drive Roller will begin to turn slowly and the following message will be displayed. Everytime the Drive Roller completes a turn, the counter will increase by one. Cancel 1.1 Turn DRIVE ROLLER 1 turn (s) Press Cancel Press CANCEL to stop 4. If you want to stop the Drive Roller from turning, press Cancel and the following message will appear on the front panel. Press Enter if you want to return to the Service Utility menu or press Back if you want to continue turning the Drive Roller. 1.1 Turn DRIVE ROLLER Stopped! Press ENTER to exit or BACK to resume Top Back ↑ Make Selection ↓ Enter 4-18 HP DesignJet 5000 Series Printers Service Manual