HP Designjet 5000 Service Manual - Page 70

System Error Codes System Error: 0B000A Problem Description: Primer Shutdown Error. Corrective Action: Try the following: n Check that the Service Station Cable (the grey flat cable with the grey connector) is plugged into the Main PCA, and that the clips of the connector are closed. Also check that the cable is not damaged. n Replace the Service Station ⇒ Page 8-67. System Error: 0B000B Problem Description: APS Failure. Corrective Action: Try the following: n Check that the cable from the Ink Supply Station (ISS) PCA to the Ink Supply Station is correctly connected. n Check that the Air Pressurization System Sensor Cable is correctly connected and is NOT damaged. n Check all the tubes of the APS and make sure they are NOT pinched or damaged. n Faulty APS. Replace the APS ⇒ Page 8-65. n If the error code continues, replace the Main PCA ⇒ Page 8-79. WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. System Error: 0B000C Problem Description: Serial Device ADC test failure. Corrective Action: Replace the Main PCA ⇒ Page 8-79. 2-18 HP DesignJet 5000 Series Printers Service Manual