HP Designjet 5000 Service Manual - Page 66
Refer to System Error Code 0A0050., Replace the ISS PCA - hard drive replacement
View all HP Designjet 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
System Error Codes System Error: 0A0050 (Non-Continuable) Problem Description: The Printer has detected a leak in the Tubes System before the life of the System. Corrective Action: Try the following: n Check for ink in the Ink Leak Detector and, if present, replace the complete Tubes System ⇒ Page 8-25. n The Ink Leak Detector could have been triggered due to condensation in the Printer. Power OFF the Printer and allow the Printer to dry for 15 minutes. Power ON and check if the System Error Code has disappeared. n Replace the ISS PCA ⇒ Page 8-86. WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. System Error: 0A0060 (Non-Continuable) Problem Description: The Printer has detected a leak in the Tubes System after the life of the System. Corrective Action: Refer to System Error Code 0A0050. System Error: 0A0070 (Continuable) Problem Description: The Backup EEROM contents stored in the Hard Disk Drive are not consistent with the ones required by the firmware. Corrective Action: Try the following: n Perform Backup EEROM ⇒ Page 4-31 and ALL calibrations. Perform EEROM Setup ⇒ Page 4-24 to reconfigure the Printer. System Error: 0B0000 Problem Description: Bad Ambient Temperature measured. Corrective Action: Try the following: n Make sure that the Ambient temperature is within the allowed range (between 0 and 55 Degrees Centigrade). n Replace the Main PCA ⇒ Page 8-79. 2-14 HP DesignJet 5000 Series Printers Service Manual