HP Designjet 5000 Service Manual - Page 138

Service Calibrations NOTE If the Media loaded is not the right size, the following message is displayed. Press Enter to exit. Load the correct media and repeat the procedure. 2.1 Scan Axis Media too small. Remove Media. Press ENTER to continue Top Back ↑ ↓ Enter Press Enter 2. If the correct media is loaded, the following message is displayed. Press Enter to confirm or Back to return to the Service Calibrations menu. 2.1 Scan Axis Press ENTER to confirm or BACK to correct Top Back ↑ Make Selection ↓ Enter 3. When the following message is displayed, you will need to enter the Line Sensor id. The Line Sensor Id. is a two digit figure in a 01 - 99 range which can be located on the label on the side of the Line Sensor Assembly on the right side of the Carriage. To insert a number use the UP and DOWN keys to scroll through a list of characters in the following ranges: 1...9 and (Backspace) to delete a character previously confirmed using the Enter key. After selecting the first digit, press Enter to insert the second digit. Press Enter to continue when both digits have been entered. Line Sensor Line Sensor Id:_ _ Use Up / Down buttons to scroll Top Back ↑ Make Selection ↓ Enter Press Enter n If the Line Sensor ID is not indicated on the Line Sensor, use the default value which is "0". In the future, if the LED's are modified, a sticker will be included with the new Line Sensor ID. 5-8 HP DesignJet 5000 Series Printers Service Manual