HP Designjet 5000 Service Manual - Page 72
Replace the Service Station Assembly
View all HP Designjet 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
System Error Codes System Error: 0C0032 (Continuable) Problem Description: Drop Detector not calibrated or the calibration settings have been lost. Corrective Action: Try the following: n Perform the Service Station Calibration ⇒ Page 5-11. n Replace the Drop Detector Assembly ⇒ Page 8-70. n Replace the Service Station Assembly ⇒ Page 8-67. WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. System Error: 0C0040 Problem Description: Error in Printhead Drop Detection. This error code appears when the Printer detects that the same area of nozzles do not work in different Printheads. The possible causes are either fibres or a piece of paper in the Drop Detector or that the Scan-Axis reference is incorrect. Corrective Action: Try the following: n Manually recover the Printheads ( ⇒ Page 6-15) and check whether the error still appears. n If the error does appear again, then check that there no fibres or pieces of paper in the Drop Detector. n If the error does not appear again, then check that the Scan-Axis stop of the Carriage is not deformed too much (some slight deformation of upto 0.5mm is normal, but if it is bigger than that, then replace the Carriage Assembly and recalibrate the Printer). n If the Scan-Axis is OK also, then replace the Drop Detector ( ⇒ Page 8-70) or the Service Station Assembly (⇒ Page 8-67) and recalibrate the Printer. 2-20 HP DesignJet 5000 Series Printers Service Manual