HP Designjet 5000 Service Manual - Page 367

NOTE NOTE Preventive Maintenance Warning/Stop Triggers If the Ink Tubes System needs to be replaced, this can be performed by the User. The Printer will advise the User when the Carriage and/or Tubes need to be replaced by displaying a Warning message. The Warning message is triggered by the following number of cycles: n 6.5 million for the Carriage. n 6.5 million for the Tubes. The number of cycles can be checked at anytime by printing the Service Configuration Print. Remember to perform the Reset Life Counters Service Utility (Refer to ⇒ Page 4-29), to set the usage cycles to zero for the worn parts replaced with parts from the Service Preventive Maintenance Kit. Service preventive maintenance messages will not disappear until the counter is reset for the part replaced. "Printer Maintenance Advised" If BOTH the Carriage and the Ink Tubes have done more than 6.5 million cycles, then this message will appear on the Front Panel. In this case, you must replace BOTH the Service Preventive Maintenance Kit and the Ink Tubes System (either Dye or UV, depending on which ink system the User has installed). "(3) Printer Maintenance Advised" If ONLY the Carriage has done more than 6.5 million cycles, then this message will appear on the Front Panel. In this case, you must replace Only the Service Preventive Maintenance Kit. "Ink Tube Maintenance Advised" If ONLY the Ink Tubes have done more than 6.5 million cycles, then this message will appear on the Front Panel. In this case, you must replace ONLY the Ink Tubes System (either Dye or UV, depending on which ink system the User has installed). HP DesignJet 5000 Series Printers Service Manual 9-3