HP Designjet 5000 Service Manual - Page 71

System Error Codes System Error: 0B000D Problem Description: 24 V source test failure. Corrective Action: Replace the Main PCA ⇒ Page 8-79. System Error: 0B000E Problem Description: At power-up, the Printer thinks it is smaller than 42 inches. Corrective Action: Try the following: n Check that there are no obstacles in the Scan-Axis which stops the Carriage from reaching the end-stops on both sides. n Check that the Carriage moves freely from side to side. n Check that the IDS Crane is installed correctly on top of the Carriage and that the Carriage Cover is clipped on correctly. System Error: 0C0030 Problem Description: Drop Detector Failure. Corrective Action: Try the following: n Check that the Drop Detector Cable is NOT broken or damaged. n Check that the Drop Detector cable is correctly connected to the Service Station Cable. n Remove the Drop Detector and make sure that there are no obstacles inside which are blocking the sensor. n Replace the Drop Detector Assembly ⇒ Page 8-70. n If the System Error Code continues, replace the Main PCA ⇒ Page 8-79. WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. HP DesignJet 5000 Series Printers Service Manual 2-19