IBM 4846-545 Service Guide - Page 103
Notes, full-size, keyboard-integration, countertop
View all IBM 4846-545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Mounting the Models 545 and 565 Notes: 1) If you are routing cables underneath the counter, route them through the cable-access hole in the counter. 2) If you are routing cables on top of the counter, route them out the back of the system. Lay them flat along the countertop. 2. For a free-standing unit, ensure that the four rubber feet A are installed on the bottom of the countertop keyboard integration tray (as shown in Figure 54 on page 82). 3. To secure the full-size keyboard-integration tray to a countertop, perform the following steps: a. Remove the fence E from the countertop keyboard-integration tray by removing the screws as shown in Figure 54 on page 82. b. Drill the four mounting holes and cut a hole in the countertop for cables if needed. Use the openings in the integration tray as a pattern for drilling mounting holes and a cable opening in the counter. c. Remove the rubber feet A located on the bottom of the integration tray. See Figure 54 on page 82 for location of feet. d. Attach the keyboard-integration tray to the countertop using four mounting screws, one at each corner of tray. The four mounting screws are not provided with the kit. Use 60-mm (0.25-in.) pan-head screws. e. Reattach the fence E to the tray with the six small screws. Chapter 4. Mounting the SurePOS 500 Models 545 and 565 81