Icom IC-7100 Advanced Instructions - Page 11

Previous view 1 PANEL DESCRIPTION Controller - Front panel (Continued) PWR AF RF/SQL i7100 TX / RX CLR M-CH BANK PBT RIT RIT TUNER/CALL MENU NB NR MIC/RF PWR SPEED/PITCH P.AMP ATT NOTCH DR SET QUICK AUTO TUNE RX�CS SPEECH XFC MPAD @5 @4 @2 @3 @2 SPEECH•LOCK KEY SPEECH ❍ SPEECH KEY Operation (p. 3-20) Push to audibly announce the S-meter level, the displayed frequency and the operating mode. • The S-Level announcement can be turned OFF in the "S-Level SPEECH" item of the "SPEECH" Set mode. (p. 17-15) SET > SPEECH > S-Level SPEECH • When RIT is ON, the RIT offset is not included in the frequency announcement. ❍ LOCK KEY Operation (p. 5-12) Hold down for 1 second to turn the Lock function ON or OFF. • The function electronically locks the Dial appears when the function is ON. • Y ou can select the Dial lock and Panel lock in the "Lock Function" item of the "Function" Set mode. (p. 17-20) SET > Function > Lock Function NOTE: The [SPEECH/LOCK] key operation to activate the voice synthesizer or the Lock functions can be replaced in the "[SPEECH/LOCK] Switch" item of the "Function" Set mode. (p. 17-20) SET > Function > Lock Function @3 MEMO PAD KEY MPAD (p. 11-13) ➥➥Push to sequentially call up the contents from the memo pad. The 5 (or 10) most recently programmed frequencies and operating modes can be recalled, starting from the most recent. • The memo pad capacity can be increased from 5 to 10 in the "Memopad Numbers" item of the "Function" Set mode (p. 17-20) SET > Function > Memopad Numbers ➥➥Hold down for 1 second to write the displayed data into a memo pad. • The 5 most recent entries remain in the memo pad. @4 MAIN DIAL Rotate to change the displayed frequency, select the Set mode settings, and so on. @5 MAIN DIAL TENSION LATCH Select the Dial drag. • Three positions are selectable. The top setting turns on clicks as the dial is turned. 1-7