Icom IC-7100 Advanced Instructions - Page 251
Programmed scan (VFO mode), gram Scan Edge channels 1A-3A and 1B-3B.
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
Previous view 12 SCAN OPERATION Programmed scan (VFO mode) A programmed scan searches for signals between Program Scan Edge channels "1A-3A" and "1B-3B." Before starting the programmed scan, scan edges must be programmed into these channels. See the previous page for scan edge programming. If the same frequencies are programmed into the Program Scan Edge channels, the programmed scan will not start. qqTouch the Memory channel number indication once or twice to select the VFO mode. (p. 3-4) wwTouch the mode icon to display the Mode selection screen, and then touch the desired operating mode. • T he operating mode can also be changed while scanning. eeTouch the frequency 'kHz' area on the display for 1 second to display the Tuning step selection screen, and then touch the desired tuning step. (p. 3-9) • The tuning step can also be changed while scanning. rrPush MENU (C) one or more times to select the "M1" (Menu 1) screen. ttTouch [SCAN](D) to display the "SCAN" screen. yyTouch [PROG](D) for 1 second, and then touch the desired scan range between "P1," "P2" and "P3." • The scan searches between programmed scan channels 1A-1B (P1), 2A-2B (P2) or 3A-3B (P3). • Example: P2: 14.000.00-14.360.00 uuTouch [PROG](D) to start the programmed scan. • T he MHz and kHz decimal points, and the selected scan range display blink while scanning. • If "Up/Down" is selected as the "MAIN DIAL (SCAN)" op- tion in the Scan Set mode, rotating the Dial changes the scanning direction. (p. 12-5) iiWhen the scan detects a signal, the scan stops, pauses or ignores it, depending on the Scan Resume function, the VSC function or the squelch status. ooPush [PROG](D) to cancel the scan. Left Display Center Right The L, R, C or D in the instructions indicate the part of the controller. L: Left side R: Right side C: Center bottom D: Display (Touch screen) Touch [SCAN] Touch [PROG] for 1 second. Touch the desired scan range (Example: P2) While Programmed scanning 12-8