Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 150

Managed Switch CLI Manual, Release 8.0 Term Admin Mode Probe Port Mirrored Port Type Definition Indicates whether the Port Mirroring feature is enabled or disabled for the session identified with . The possible values are Enabled and Disabled. Probe port (destination port) for the session identified with . If probe port is not set then this field is blank. The port, which is configured as mirrored port (source port) for the session identified with . If no source port is configured for the session then this field is blank. Direction in which source port configured for port mirroring.Types are tx for transmitted packets and rx for receiving packets. Static MAC Filtering The commands in this section describe how to configure static MAC filtering. Static MAC filtering allows you to configure destination ports for a static multicast MAC filter irrespective of the platform. macfilter This command adds a static MAC filter entry for the MAC address on the VLAN . The value of the parameter is a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF. The parameter must identify a valid VLAN. The number of static mac filters supported on the system is different for MAC filters where source ports are configured and MAC filters where destination ports are configured. • For unicast MAC address filters and multicast MAC address filters with source port lists, the maximum number of static MAC filters supported is 20. • For multicast MAC address filters with destination ports configured, the maximum number of static filters supported is 256. i.e. For current platforms, you can configure the following combinations: • Unicast MAC and source port (max = 20) • Multicast MAC and source port (max=20) • Multicast MAC and destination port (only) (max=256) Switching Commands v1.0, July 2009 3-114