Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 246

Managed Switch CLI Manual, Release 8.0 no ip route default This command deletes all configured default routes. If the optional parameter is designated, the specific next hop is deleted from the configured default route and if the optional preference value is designated, the preference of the configured default route is reset to its default. Format Mode no ip route default [{ | }] Global Config ip route distance This command sets the default distance (preference) for static routes. Lower route distance values are preferred when determining the best route. The ip route and ip route default commands allow you to optionally set the distance (preference) of an individual static route. The default distance is used when no distance is specified in these commands. Changing the default distance does not update the distance of existing static routes, even if they were assigned the original default distance. The new default distance will only be applied to static routes created after invoking the ip route distance command. Default Format Mode 1 ip route distance Global Config no ip route distance This command sets the default static route preference value in the router. Lower route preference values are preferred when determining the best route. Format Mode no ip route distance Global Config ip netdirbcast This command enables the forwarding of network-directed broadcasts. When enabled, network directed broadcasts are forwarded. When disabled they are dropped. Default disabled Routing Commands v1.0, July 2009 4-11