Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 460

Managed Switch CLI Manual, Release 8.0 when connecting to the RADIUS accounting server. If a is already configured for the accounting server, the new replaces the previously configured . The must be a value in the range 0 - 65535, with 1813 being the default. Note: To re-configure a RADIUS accounting server to use the default UDP , set the parameter to 1813. Format Mode radius server host {auth | acct} {} [name ] [port ][server-type] Global Config Field ipaddr dnsname 0-65535 servername Description The IP address of the server. The DNS name of the server. The port number to use to connect to the specified RADIUS server. The alias name to identify the server. no radius server host The no version of this command deletes the configured server entry from the list of configured RADIUS servers. If the RADIUS authenticating server being removed is the active server in the servers that are identified by the same server name, then the RADIUS client selects another server for making RADIUS transactions. If the 'auth' token is used, the previously configured RADIUS authentication server is removed from the configuration. Similarly, if the 'acct' token is used, the previously configured RADIUS accounting server is removed from the configuration. The parameter must match the IP address or dns name of the previously configured RADIUS authentication / accounting server. Format Mode no radius server host {auth | acct} {} Global Config The following shows an example of the command. (Switch) (Config) #radius server host acct 192.168.37.60 (Switch) (Config) #radius server host acct 192.168.37.60 port 1813 Management Commands v1.0, July 2009 7-55