Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 315

Managed Switch CLI Manual, Release 8.0 Term Definition Match All Protocol Indicates whether this access list applies to every packet. Possible values are True or False. The protocol to filter for this rule. Source IP Address Source L4 Port Keyword Destination IP Address Destination L4 Port Keyword IP DSCP Flow Label The source IP address for this rule. The source port for this rule. The destination IP address for this rule. The destination port for this rule. The value specified for IP DSCP. The value specified for IPv6 Flow Label. Log Displays when you enable logging for the rule. Assign Queue The queue identifier to which packets matching this rule are assigned. Mirror Interface The unit/slot/port to which packets matching this rule are copied. Redirect Interface The unit/slot/port to which packets matching this rule are forwarded. Auto-Voice over IP Commands This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands. The Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and provides them with a better class-of-service than ordinary traffic. When you enable the Auto-VoIP feature on an interface, the interface scans incoming traffic for the following call-control protocols: • Session Initiation Protocol (SIP) • H.323 • Skinny Client Control Protocol (SCCP) When a call-control protocol is detected, the switch assigns the traffic in that session to the highest CoS queue, which is generally used for time-sensitive traffic. auto-voip all Use this command to enable VoIP Profile on the interfaces of the switch. Quality of Service (QoS) Commands v1.0, July 2009 5-48