Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 401

Managed Switch CLI Manual, Release 8.0 Field Receiver IP Receiver Port Description The sFlow receiver IP address. If set to 0.0.0.0, no sFlow datagrams will be sent. The default is 0.0.0.0. The destination Layer4 UDP port for sFlow datagrams. The range is 1-65535. The default is 6343. no sflow receiver Use this command to set the sFlow collector parameters back to the defaults. Format Mode no sflow receiver {ip | maxdatagram | owner timeout | port } Global Config sflow sampler A data source configured to collect flow samples is called a poller. Use this command to configure a new sFlow sampler instance for this data source if is valid. Format Mode sflow sampler { | rate | maxheadersize } Interface Config Field Description Receiver Index The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. A value of zero (0) means that no receiver is configured, no packets will be sampled. Only active receivers can be set. If a receiver expires, then all samplers associated with the receiver will also expire. Possible values are 1-8. The default is 0. Maxheadersize Sampling Rate The maximum number of bytes that should be copied from the sampler packet. The range is 20-256. The default is 128. When set to zero (0), all the sampler parameters are set to their corresponding default value. The statistical sampling rate for packet sampling from this source. A sampling rate of 1 counts all packets. A value of zero (0) disables sampling. A value of N means that out of N incoming packets, 1 packet will be sampled. The range is 1024-65536 and 0. The default is 0. Utility Commands v1.0, July 2009 6-84