Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 44

Managed Switch CLI Manual, Release 8.0 Term Interface Type Admin Mode Physical Mode Physical Status Link Status Link Trap LACP Mode Definition Valid unit, slot, and port number separated by forward slashes. If not blank, this field indicates that this port is a special type of port. The possible values are: • Mirror - this port is a monitoring port. For more information, see "Port Mirroring" on page 3-112. • PC Mbr- this port is a member of a port-channel (LAG). • Probe - this port is a probe port. The Port control administration state. The port must be enabled in order for it to be allowed into the network. - May be enabled or disabled. The factory default is enabled. The desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex mode and speed is set from the auto-negotiation process. Note that the maximum capability of the port (full duplex -100M) is advertised. Otherwise, this object determines the port's duplex mode and transmission rate. The factory default is Auto. The port speed and duplex mode. The Link is up or down. This object determines whether or not to send a trap when link status changes. The factory default is enabled. LACP is enabled or disabled on this port. show port protocol This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated group. Format Mode show port protocol { | all} Privileged EXEC Term Group Name Group ID Protocol(s) VLAN Interface(s) Definition The group name of an entry in the Protocol-based VLAN table. The group identifier of the protocol group. The type of protocol(s) for this group. The VLAN associated with this Protocol Group. Lists the unit/slot/port interface(s) that are associated with this Protocol Group. Switching Commands 3-8 v1.0, July 2009