Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 307

Managed Switch CLI Manual, Release 8.0 ip access-list rename This command changes the name of an IP Access Control List (ACL). The parameter is the names of an existing IP ACL. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IP access list. This command fails is an IP ACL by the name already exists. Format Mode ip access-list rename Global Config {deny | permit} (IP ACL) This command creates a new rule for the current IP access list. Each rule is appended to the list of configured rules for the list. Note: The 'no' form of this command is not supported, since the rules within an IP ACL cannot be deleted individually. Rather, the entire IP ACL must be deleted and respecified. Note: An implicit 'deny all' IP rule always terminates the access list. Note: For the GSM7328Sv1 and GSM7352Sv1, the mirror and redirect parameters are not available. Note: For the GSM7328Sv2 and GSM7352Sv2-based systems, the mirror parameter allows the traffic matching this rule to be copied to the specified , while the redirect parameter allows the traffic matching this rule to be forwarded to the specified . The assign-queue and redirect parameters are only valid for a permit rule. A rule may either deny or permit traffic according to the specified classification fields. At a minimum, either the every keyword or the protocol, source address, and destination address values must be specified. The source and destination IP address fields may be specified using the Quality of Service (QoS) Commands v1.0, July 2009 5-40