Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 18

Managed Switch CLI Manual, Release 8.0 Table 5. CLI Command Modes Command Mode Prompt User EXEC Switch> Privileged EXEC Switch# Global Config Switch (Config)# VLAN Config Interface Config Line Config Switch (Vlan)# Switch (Interface )# Switch (Interface Loopback )# Switch (Interface Tunnel )# Switch (line)# Policy Map Config Policy Class Config Switch (Config-policy-map)# Switch (Config-policy-class-map)# Class Map Config Switch (Config-class-map)# Ipv6_Class-Map Switch (Config-class-map)# Config Router OSPF Config Switch (Config-router)# Router OSPFv3 Config Switch (Config rtr)# Router RIP Config Switch (Config-router)# Router BGP Config Switch (Config-router)# MAC Access-list Switch (Config-mac-access-list)# Config Mode Description Contains a limited set of commands to view basic system information. Allows you to issue any EXEC command, enter the VLAN mode, or enter the Global Configuration mode. Groups general setup commands and permits you to make modifications to the running configuration. Groups all the VLAN commands. Manages the operation of an interface and provides access to the router interface configuration commands. Use this mode to set up a physical port for a specific logical connection operation. Contains commands to configure outbound telnet settings and console interface settings. Contains the QoS Policy-Map configuration commands. Consists of class creation, deletion, and matching commands. The class match commands specify Layer 2, Layer 3, and general match criteria. Contains the QoS class map configuration commands for IPv4. Contains the QoS class map configuration commands for IPv6. Contains the OSPF configuration commands. Contains the OSPFv3 configuration commands. Contains the RIP configuration commands. Contains the BGP4 configuration commands. Allows you to create a MAC Access-List and to enter the mode containing MAC Access-List configuration commands. Using the Command-Line Interface 1-6 v1.0, July 2009