Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 60

Managed Switch CLI Manual, Release 8.0 show spanning-tree interface This command displays the settings and parameters for a specific switch port within the common and internal spanning tree. The is the desired switch port. The following details are displayed on execution of the command. Format Mode show spanning-tree interface • Privileged EXEC • User EXEC Term Definition Hello Time Admin hello time for this port. Port Mode Enabled or disabled. BPDU Guard Effect Enabled or disabled. Root Guard Enabled or disabled. Loop Guard Enabled or disabled. TCN Guard Enable or disable the propagation of received topology change notifications and topology changes to other ports. BPDU Filter Mode Enabled or disabled. BPDU Flood Mode Enabled or disabled. Auto Edge To enable or disable the feature that causes a port that has not seen a BPDU for 'edge delay' time, to become an edge port and transition to forwarding faster. Port Up Time Since Time since port was reset, displayed in days, hours, minutes, and seconds. Counters Last Cleared STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent. STP BPDUs Received Spanning Tree Protocol Bridge Protocol Data Units received. RSTP BPDUs Transmitted Rapid Spanning Tree Protocol Bridge Protocol Data Units sent. RSTP BPDUs Received Rapid Spanning Tree Protocol Bridge Protocol Data Units received. MSTP BPDUs Transmitted Multiple Spanning Tree Protocol Bridge Protocol Data Units sent. MSTP BPDUs Received Multiple Spanning Tree Protocol Bridge Protocol Data Units received. Switching Commands v1.0, July 2009 3-24