Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 415

Managed Switch CLI Manual, Release 8.0 enable authentication To specify authentication method list when the user accesses a higher privilege level in remote telnet or console, use the enable authentication command in line configuration mode.. Format Mode enable authentication {default | list-name} Line Config no enable authentication To return to the default specified by the enable authentication command. Format Mode no enable authentication {default | list-name} Line Config show serial This command displays serial communication settings for the switch. Format Modes show serial • Privileged EXEC • User EXEC Term Definition Serial Port Login The time, in minutes, of inactivity on a Serial port connection, after which the Switch will Timeout close the connection. Any numeric value between 0 and 160 is allowed, the factory default (minutes) is 5. A value of 0 disables the timeout. Baud Rate (bps) The default baud rate at which the serial port will try to connect. The available values are 1200, 2400, 4800, 9600, 19200, 38400,57600, and 115200 baud. The factory default is 9600 baud. Character Size (bits) Flow Control Stop Bits Parity Type The number of bits in a character. The number of bits is always 8. Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is always disabled. The number of Stop bits per character. The number of Stop bits is always 1. The Parity Method used on the Serial Port. The Parity Method is always None. Management Commands v1.0, July 2009 7-10