Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 408

Managed Switch CLI Manual, Release 8.0 The following is an example of an ezconfig session. NETGEAR EZ Configuration Utility Hello and Welcome! This utility will walk you thru assigning the IP address for the switch management CPU. It will allow you to save the changes at the end. After the session, simply use the newly assigned IP address to access the Web GUI using any public domain Web browser. Admin password not defined. Do you want to change the password? (Y/N/Q) y Enter new password:******** Confirm new password:******** Password Changed! The 'enable' password required for switch configuration via the command line interface is currently not configured. Do you wish to change it (Y/N/ Q)? y Enter new password:******** Confirm new password:******** Password Changed! Assigning an IP address to your switch management Current IP Address Configuration IP address: 0.0.0.0 Subnet mask: 0.0.0.0 Gateway address: 0.0.0.0 Would you like to assign an IP address now (Y/N/Q)? y IP Address: 10.10.10.1 Subnet mask: 255.255.255.0 Gateway address: 10.10.10.10 Do you want to assign switch name and location information (Y/N/Q)? y System Name: testunit1 System Location: testlab System Contact: Bud Lightyear Management Commands 7-3 v1.0, July 2009