Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 501

Managed Switch CLI Manual, Release 8.0 Table 8-48: PIM-SM Log Messages Component PIM-SM PIM-SM PIM-SM PIM-SM PIM_SM PIM-SM Message Cause PIM-SM not initialized Unable to take xxx semaphore This message arises when trying to activate pimsm interfaces or receiving pimsm packets when pimsm component is not initialized. This message is logged when failed to acquire semaphore to access source list or group list or candidate Rp list or virtual interface list. The xxx specifies the list for which the access is denied. Warning : Could not send packet type xxx (pimsm packet type) on rtrIfNum this warning is logged when failed to send a pimsm control packet on the specified router interface. add_kernel_cache : memory allocation failed This message is logged when there is insufficient memory to add an mroute entry into cache. Config error. Trying to add static RP. Dynamic RP with same ip addr exists Router learns RP-group mapping through Bootstrap messages received.This message pops when the static RP is configured which conflicts the mapping learnt dynamically through Bootstrap messages. Inner xxx(source/group) address of register This log message appears when a register message is invalid message is received with invalid inner ip source or group address. Table 8-49: PIM-DM Log Messages Component PIM-DM PIM-DM PIM-DM PIM-DM Message Cause Out of memory when creating xxx Error entry->ll_xxx LL creation error This message is logged when there is insufficient memory to accommodate a new neighbor/(S,G) Entry, Prune, Graft, Join etc. This message is logged when the SLL creation is Failed. pim_interface_set: Could not give taskSema This message is logged when Task synchronization Semaphore release fails. Error initializing CACHE This message is logged when the PIM-DM (S,G) entry Cache table initialization fails. Log Messages v1.0, July 2009 8-22