Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 419

Managed Switch CLI Manual, Release 8.0 no session-timeout This command sets the Telnet session timeout value to the default. The timeout value unit of time is minutes. Format Mode no session-timeout Line Config telnetcon maxsessions This command specifies the maximum number of Telnet connection sessions that can be established. A value of 0 indicates that no Telnet connection can be established. The range is 0-5. Default Format Mode 4 telnetcon maxsessions Privileged EXEC no telnetcon maxsessions This command sets the maximum number of Telnet connection sessions that can be established to the default value. Format Mode no telnetcon maxsessions Privileged EXEC telnetcon timeout This command sets the Telnet connection session timeout value, in minutes. A session is active as long as the session has not been idle for the value set. The time is a decimal value from 1 to 160. Note: When you change the timeout value, the new value is applied to all active and inactive sessions immediately. Any sessions that have been idle longer than the new timeout value are disconnected immediately. Default Format Mode 5 telnetcon timeout Privileged EXEC Management Commands v1.0, July 2009 7-14