Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 292

Managed Switch CLI Manual, Release 8.0 policy-map rename This command changes the name of a DiffServ policy. The is the name of an existing DiffServ class. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the policy. Format Mode policy-map rename Global Config DiffServ Service Commands Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you specified by using the policy commands, to an interface in the incoming direction The service commands attach a defined policy to a directional interface. You can assign only one policy at any one time to an interface in the inbound direction. DiffServ is not used in the outbound direction. This set of commands consists of service addition/removal. The CLI command root is service-policy. service-policy This command attaches a policy to an interface in the inbound direction. The parameter is the name of an existing DiffServ policy. This command causes a service to create a reference to the policy. Note: This command effectively enables DiffServ on an interface in the inbound direction. There is no separate interface administrative 'mode' command for DiffServ. Note: This command fails if any attributes within the policy definition exceed the capabilities of the interface. Once a policy is successfully attached to an interface, any attempt to change the policy definition, that would result in a violation of the interface capabilities, causes the policy change attempt to fail. Quality of Service (QoS) Commands v1.0, July 2009 5-25