Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 394

Managed Switch CLI Manual, Release 8.0 debug ping packet This command enables tracing of ICMP echo requests and responses. The command traces pings on the network port/ serviceport for switching packages. For routing packages, pings are traced on the routing ports as well. Default Format Mode disabled debug ping packet Privileged EXEC A sample output of the trace message is shown below. JAN 01 00:21:22 192.168.17.29-1 SIM[181040176]: sim_debug.c(128) 20 % Pkt TX - Intf: 1/0/1(1), SRC_IP:10.50.50.2, DEST_IP:10.50.50.1, Type:ECHO_REQUEST JAN 01 00:21:22 192.168.17.29-1 SIM[182813968]: sim_debug.c(82) 21 % Pkt RX - Intf: 1/0/1(1), S RC_IP:10.50.50.1, DEST_IP:10.50.50.2, Type:ECHO_REPLY The following parameters are displayed in the trace message: Parameter TX/RX Intf SRC_IP DEST_IP Type Definition TX refers to a packet transmitted by the device. RX refers to packets received by the device. The interface that the packet came in or went out on. Format used is unit/slot/port (internal interface number). Unit is always shown as 1 for interfaces on a non-stacking device. The source IP address in the IP header in the packet. The destination IP address in the IP header in the packet. Type determines whether or not the ICMP message is a REQUEST or a RESPONSE. no debug ping packet This command disables tracing of ICMP echo requests and responses. Format Mode no debug ping packet Privileged EXEC Utility Commands v1.0, July 2009 6-77