Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 275

Managed Switch CLI Manual, Release 8.0 If you specify the interface, the command also displays the following information. Term Interface Interface Shaping Rate Definition The unit/slot/port of the interface. If displaying the global configuration, this output line is replaced with a Global Config indication. The maximum transmission bandwidth limit for the interface as a whole. It is independent of any per-queue maximum bandwidth value(s) in effect for the interface. This is a configured value. Differentiated Services (DiffServ) Commands This section describes the commands you use to configure QOS Differentiated Services (DiffServ). You configure DiffServ in several stages by specifying three DiffServ components: 1. Class a. Creating and deleting classes. b. Defining match criteria for a class. 2. Policy a. Creating and deleting policies b. Associating classes with a policy c. Defining policy statements for a policy/class combination 3. Service a. Adding and removing a policy to/from an inbound interface The DiffServ class defines the packet filtering criteria. The attributes of a DiffServ policy define the way the switch processes packets. You can define policy attributes on a per-class instance basis. The switch applies these attributes when a match occurs. Packet processing begins when the switch tests the match criteria for a packet. The switch applies a policy to a packet when it finds a class match within that policy. The following rules apply when you create a DiffServ class: • Each class can contain a maximum of one referenced (nested) class • Class definitions do not support hierarchical service policies Quality of Service (QoS) Commands 5-8 v1.0, July 2009