Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 308

Managed Switch CLI Manual, Release 8.0 keyword 'any' to indicate a match on any value in that field. The remaining command parameters are all optional, but the most frequently used parameters appear in the same relative order as shown in the command format. The assign-queue parameter allows specification of a particular hardware queue for handling traffic that matches this rule. The allowed value is 0-(n-1), where n is the number of user configurable queues available for the hardware platform. The assign-queue parameter is valid only for a permit rule. Format Mode {deny | permit} {every | {{icmp | igmp | ip | tcp | udp | } [{eq { | } [{eq {| }] [precedence | tos | dscp ] [log] [assign-queue ] [{mirror | redirect} ] Ipv4-Access-List Config ip access-group This command either attaches a specific IP ACL identified by to an interface or associates with a VLAN ID in a given direction. The parameter is the name of the Access Control List. An optional sequence number may be specified to indicate the order of this IP access list relative to other IP access lists already assigned to this interface and direction. A lower number indicates higher precedence order. If a sequence number is already in use for this interface and direction, the specified access list replaces the currently attached IP access list using that sequence number. If the sequence number is not specified for this command, a sequence number that is one greater than the highest sequence number currently in use for this interface and direction is used. Note: You should be aware that the option may or may not be available, depending on the platform. Default Format Modes none ip access-group [vlan ] [sequence ] • Interface Config • Global Config Quality of Service (QoS) Commands v1.0, July 2009 5-41