Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 499

Managed Switch CLI Manual, Release 8.0 Table 8-41: VRRP Log Messages Component VRRP Message Changing priority to 255 for virtual router with VRID 1 on interface 1/0/1 VRRP VRRP Changing priority to 100 for virtual router with VRID 1 on interface 1/0/1 vrrpPacketValidate: Invalid TTL Cause When the router is configured with the address being used as the virtual router ID, the router's priority is automatically set to the maximum value to ensure that the address owner becomes the VRRP master. When the router is no longer the address owner, Switch CLI reverts the router's priority to the default. VRRP ignored an incoming message whose time to live (TTL) in the IP header was not 255. Table 8-42: ARP Log Message Component ARP Message Cause ARP received mapping for IP address xxx to MAC address yyy. This IP address may be configured on two stations. When we receive an ARP response with different MAC address from another station with the same IP address as ours. This might be a case of misconfiguration. Table 8-43: RIP Log Message Component RIP Message RIP : discard response from xxx via unexpected interface Cause When RIP response is received with a source address not matching the incoming interface's subnet. Table 8-44: DHCP6 Log Message Component DHCP6 Message Cause relay_to_server: Cannot relay to relay server Relay is enabled but neither the outgoing intf xxx: not IPv6 enabled interface nor the server IP address is specified. Log Messages v1.0, July 2009 8-20