Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 494

Managed Switch CLI Manual, Release 8.0 Table 8-30: 802.1Q Log Messages Component 802.1Q 802.1Q 802.1Q 802.1Q 802.1Q Message Cause dot1qIssueCmd: Unable to send message dot1qMsgQueue is full. %d to dot1qMsgQueue for vlan %d - %d msgs in queue dot1qVlanCreateProcess: Attempt to create This accommodates for reserved vlan ids. a vlan with an invalid vlan id %d ; i.e. 4094 - x VLAN %d not in range, dot1qMapIntfIsConfigurable: Error accessing DOT1Q config data for interface %d in dot1qMapIntfIsConfigurable. A default configuration does not exist for this interface. Typically a case when a new interface is created and has no preconfiguration. dot1qVlanDeleteProcess: Deleting the default VLAN Typically encountered during clear Vlan and clear config dot1qVlanMemberSetModify, dot1qVlanTaggedMemberSetModify: Dynamic entry %d can only be modified after it is converted to static If this vlan is a learnt via GVRP then we cannot modify it's member set via management. Table 8-31: 802.1S Log Messages Component 802.1S 802.1S 802.1S Message Cause dot1sIssueCmd: Dot1s Msg Queue is full!!!!Event: %u, on interface: %u, for instance: %u The message Queue is full. dot1sStateMachineRxBpdu(): Rcvd BPDU Discarded The current conditions, like port is not enabled or we are currently not finished processing another BPDU on the same interface, does not allow us to process this BPDU dot1sBpduTransmit(): could not get a buffer Out of system buffers Table 8-32: Port Mac Locking Log Message Component Port Mac Locking Message Cause pmlMapIntfIsConfigurable: Error accessing PML config data for interface %d in pmlMapIntfIsConfigurable. A default configuration does not exist for this interface. Typically a case when a new interface is created and has no preconfiguration. Log Messages v1.0, July 2009 8-15