Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 402

Managed Switch CLI Manual, Release 8.0 no sflow sampler Use this command to reset the sFlow sampler instance to the default settings. Format Mode no sflow sampler { | rate | maxheadersize } Interface Config sflow poller A data source configured to collect counter samples is called a poller. Use this command to enable a new sFlow poller instance for this data source if is valid. Format Mode sflow poller { | interval } Interface Config Field Description Receiver Index Enter the sFlow Receiver associated with the sampler/poller. A value of zero (0) means that no receiver is configured. The range is 1-8. The default is 0. Poll Interval Enter the sFlow instance polling interval. A poll interval of zero (0) disables counter sampling. When set to zero (0), all the poller parameters are set to their corresponding default value. The range is 0-86400. The default is 0. A value of N means once in N seconds a counter sample is generated. no sflow poller Use this command to reset the sFlow poller instance to the default settings. Format Mode no sflow poller { | interval } Interface Config Utility Commands v1.0, July 2009 6-85