Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 437

Managed Switch CLI Manual, Release 8.0 username snmpv3 encryption This command specifies the encryption protocol used for the specified user. The valid encryption protocols are des or none. If you select des, you can specify the required key on the command line. The encryption key must be 8 to 64 characters long. If you select the des protocol but do not provide a key, the user is prompted for the key. When you use the des protocol, the login password is also used as the snmpv3 encryption password, so it must be a minimum of eight characters. If you select none, you do not need to provide a key. The value is the login user name associated with the specified encryption. You must enter the in the same case you used when you added the user. To see the case of the , enter the show users command. Default Format Mode no encryption username snmpv3 encryption {none | des[key]} Global Config no username snmpv3 encryption This command sets the encryption protocol to none. The is the login user name for which the specified encryption protocol will be used. Format Mode no username snmpv3 encryption Global Config show users This command displays the configured user names and their settings. This command is only available for users with Read/Write privileges. The SNMPv3 fields will only be displayed if SNMP is available on the system. Format Mode show users Privileged EXEC Term User Name Definition The name the user enters to login using the serial port, Telnet or Web. Management Commands v1.0, July 2009 7-32