Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 26

Managed Switch CLI Manual, Release 8.0 member This command configures a switch. The is the switch identifier of the switch to be added/removed from the stack. The is the index into the database of the supported switch types, indicating the type of the switch being preconfigured. The switch index is a 32-bit integer. This command is executed on the Primary Management Unit. Format Mode member Stack Global Config Note: Switch index can be obtained by executing the show supported switchtype command in User EXEC mode. no member This command removes a switch from the stack. The is the switch identifier of the switch to be removed from the stack. This command is executed on the Primary Management Unit. Format Mode no member Stack Global Config switch priority This command configures the ability of a switch to become the Primary Management Unit. The is the switch identifier. The is the preference parameter that allows the user to specify, priority of one backup switch over another. The range for priority is 1 to 15. The switch with the highest priority value will be chosen to become the Primary Management Unit if the active Primary Management Unit fails. The switch priority defaults to the hardware management preference value 1. Switches that do not have the hardware capability to become the Primary Management Unit are not eligible for management. Default Format Mode enabled switch priority Global Config Stacking Commands 2-2 v1.0, July 2009