Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 342

Managed Switch CLI Manual, Release 8.0 Example: The following are examples of the CLI command. traceroute Success: (Switch) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 10.240.10.115 ,4 hops max 43 byte packets: 1 10.240.4.1 708 msec 41 msec 11 msec 2 10.240.10.115 0 msec 0 msec 0 msec Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6 traceroute Failure: (Switch) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 10.40.1.1 ,30 hops max 43 byte packets: 1 10.240.4.1 19 msec 18 msec 9 msec 2 10.240.1.252 0 msec 0 msec 1 msec 3 172.31.0.9 277 msec 276 msec 277 msec 4 10.254.1.1 289 msec 327 msec 282 msec 5 10.254.21.2 287 msec 293 msec 296 msec 6 192.168.76.2 290 msec 291 msec 289 msec 7 0.0.0.0 0 msec * Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18 traceroute ipv6 Use the traceroute command to discover the routes that packets actually take when traveling to their destination through the network on a hop-by-hop basis. The parameter must be a valid IPv6 address or hostname. The optional parameter is the UDP port used as the destination of packets sent as part of the traceroute. This port should be an unused port on the destination system. The range for is zero (0) to 65535. The default value is 33434. Default Format Mode port: 33434 traceroute ipv6 [port ] Privileged EXEC Utility Commands v1.0, July 2009 6-25