Netgear FSM726v3 7200 managed switch v8.x CLI reference manual - Page 221

Managed Switch CLI Manual, Release 8.0 Default Format Mode disabled dos-control udppport Global Config no dos-control udpport This command disables UDP L4 source = destination port number (Source UDP Port =Destination UDP Port) Denial of Service protection. This command is only available on FSM72xxRS switches. Format Mode no dos-control udppport Global Config dos-control tcpflagseq This command enables TCP Flag and Sequence Denial of Service protections. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress having TCP Flag SYN set and a source port less than 1024 or having TCP Control Flags set to 0 and TCP Sequence Number set to 0 or having TCP Flags FIN, URG, and PSH set and TCP Sequence Number set to 0 or having TCP Flags SYN and FIN both set, the packets will be dropped if the mode is enabled. This command is only available on FSM72xxRS switches. Default Format Mode disabled dos-control tcpflagseq Global Config no dos-control tcpflagseq This command sets disables TCP Flag and Sequence Denial of Service protection. This command is only available on FSM72xxRS switches. Format Mode no dos-control tcpflagseq Global Config Switching Commands v1.0, July 2009 3-185