Canon XF705 Instruction Manual - Page 207
Playback, Indicator, and On, creen Di, Tally Lamp Front] or [Tally Lamp Rear] to [On].
View all Canon XF705 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
Troubleshooting The camcorder cannot record to the SD card properly. - This may occur as recordings are made and deleted over time. Save your recordings (A 153) and initialize the card (A 35). After using the camcorder for a long time, it becomes hot. - The camcorder may become hot after using it continuously for long periods of time; this is not a malfunction. If the camcorder becomes unusually hot or it becomes hot after using it only for a short while, it may indicate a problem with the camcorder. Consult a Canon Service Center. 207 Playback Cannot delete a clip. - The XF-HEVC or XF-AVC clip may have an $ mark. Remove the $ mark (A 141). - The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch. Deleting clips takes longer than usual. - When the SD card contains a large number of clips, some operations may take longer than usual. Save your recordings (A 153) and initialize the card (A 35). Cannot copy clips. - There is not enough available space on the destination card or the card already contains the maximum number of clips (999 clips). Delete some clips (A 142) to free some space or replace the card. Cannot delete a photo. - The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch. - Photos that were protected using other devices cannot be deleted with the camcorder. Indicators and Onscreen Displays appears in red on the screen. - The battery pack is exhausted. Replace or charge the battery pack. í appears on the screen. - The camcorder cannot communicate with the battery pack attached so the remaining battery time cannot be displayed. The tally lamp does not illuminate. - Set > [$ System Setup] > [LED] > [Tally Lamp (Front)] or [Tally Lamp (Rear)] to [On]. The tally lamp flashes quickly. (4 flashes per second) - The battery pack is exhausted. Replace or charge the battery pack. - There is not enough available space on the SD card. Delete some clips (A 142) to free some space or replace the selected card. - A system error has occurred. Turn the camcorder off and then on again. If this does not solve the problem, consult a Canon Service Center. The tally lamp flashes slowly. (1 flash per second) - The combined available space on both cards is low. Replace the card that is not being recorded onto. / appears in red on the screen. - A card error occurred. Remove and reinsert the card. If the display does not change back to normal, save your recordings (A 153) and initialize the card (A 35). 6/7 (in red) and [END] appear on the screen. - The SD card is full. Use a different card or delete some clips (A 142) to free some space on the card. Even after stopping recording, the access indicator stays illuminated in red. - The clip is being recorded on the card. This is not a malfunction. b appears in yellow on the screen. - The camcorder's internal temperature has reached a predetermined level. You can continue using the camcorder. b appears in red on the screen. - The camcorder's internal temperature has risen further while b appeared in yellow on the screen. - If the icon appears in red in mode while > [% System Setup] > [Fan] is set to [Always On], turn off the camcorder and wait until the temperature has decreased. - In mode, if [Fan] is set to [Automatic] and the fan was turned off while recording, the fan will turn on automatically (in that case, ` will appear on the screen).