Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 123
retention hooks., When the backplane cannot slide upward any farther, pull
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
10 Remove the SAS backplane from the system: a If you are removing a 2.5-inch drive backplane, press the spring-loaded blue retention tab towards the front of the system, slide the backplane upward. See Figure 3-30. If you are removing a 3.5-inch drive backplane, pull the spring-loaded blue retention pin away from the front of the backplane, then slide the backplane upward. See Figure 3-31. b When the backplane cannot slide upward any farther, pull the backplane toward the back of the system to remove it from the retention hooks. c Lift the board out of the system, being careful to avoid damaging components on the face of the board. d Place the SAS backplane face down on a work surface. Installing System Components 123
Installing System Components
123
10
Remove the SAS backplane from the system:
a
If you are removing a 2.5-inch drive backplane,
press the spring-loaded
blue retention tab towards the front of the system, slide the backplane
upward. See Figure 3-30.
If you are removing a 3.5-inch drive backplane,
pull the spring-loaded
blue retention pin away from the front of the backplane, then slide the
backplane upward. See Figure 3-31.
b
When the backplane cannot slide upward any farther, pull the
backplane toward the back of the system to remove it from the
retention hooks.
c
Lift the board out of the system, being careful to avoid damaging
components on the face of the board.
d
Place the SAS backplane face down on a work surface.