Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 139
Processor Expansion Module Board (Service- Only Procedure), Removing the PEM Board
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
5 Close the system. See "Closing the System" on page 66. 6 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. Processor Expansion Module Board (ServiceOnly Procedure) Removing the PEM Board 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 65. 3 Remove the PEM. See "Removing the PEM or PEM Shell" on page 73. 4 Remove the PEM cooling shroud. See Figure 3-9. 5 Remove the PEM board: a Pull up the spring-loaded blue retention pin located in the center of the PEM board, and then slide the board toward the front of the PEM shell until it stops. See Figure 3-35. b Lift the PEM board out of the PEM shell. Installing System Components 139