Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 172
System Board Connectors
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening and Closing the System" on page 65. 3 Move the password jumper to pins 2-4 to clear the password. See Figure 6-1 to locate the password jumper on the system board. 4 Close the system. 5 Reconnect your system and peripherals to their electrical outlets, and turn on the system. The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed. However, before you assign a new system and/or setup password, you must install the jumper plug. NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system disables the new password(s) the next time it boots. 6 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 7 Open the system. See "Opening and Closing the System" on page 65. 8 Move the password jumper to pins 4-6 to restore the password function. 9 Close the system. 10 Reconnect your system and peripherals to their electrical outlets, and turn on the system. 11 Assign a new system and/or setup password. To assign a new password using the System Setup program, see "Assigning a System Password" on page 55. System Board Connectors See Figure 6-1 and Table 6-2 for the location and description of the system board connectors. 172 Jumpers and Connectors