Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 96
Removing the Cooling Shroud Assembly
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
4 Remove the cooling shroud assembly: - If you are installing memory modules on the system board, see "Removing the Cooling Shroud Assembly" on page 69. - If you are installing memory modules on the PEM, see Figure 3-9. 5 Locate the memory module sockets. See Figure 6-1 or Figure 6-2. 6 Press the ejectors on the memory module socket down and out, as shown in Figure 3-19, to allow the memory module to be inserted into the socket. 7 Handle each memory module only on either card edge, ensuring not to touch the middle of the memory module. Figure 3-19. Installing and Removing a Memory Module 1 2 3 1 memory module 3 alignment key 2 memory module socket ejectors (2) 8 Align the memory module's edge connector with the alignment key of the memory module socket, and insert the memory module in the socket. NOTE: The memory module socket has an alignment key that allows you to install the memory module in the socket in only one way. 96 Installing System Components