Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 35
Gate A20 failure, Access Controller
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Table 1-8. System Messages (continued) Message Causes Corrective Actions Error: Incorrect memory configuration CPU n The DIMM group for CPU n is incorrectly configured and caused the system to halt. See "General Memory Module Installation Guidelines" on page 92 for memory configuration information. If the problem persists, see "Troubleshooting System Memory" on page 156. !*** Error: Remote Access Controller initialization failure *** RAC virtual USB devices may not be available... Remote Access Controller Ensure that the Remote initialization failure Access Controller is properly installed. See "Installing an Optional RAC Card" on page 83. Gate A20 failure Faulty keyboard See "Getting Help" on controller; faulty system page 179. board. General failure The operating system is unable to carry out the command. This message is usually followed by specific information. Note the information and take the appropriate action to resolve the problem. HyperTransport error caused a system reset: HyperTransport device Please check the system event log for details. A fatal system error occurred and caused the system to reboot. Check the SEL for information that was logged during the error. See the applicable troubleshooting section in "Troubleshooting Your System" on page 143 for any faulty components specified in the SEL. About Your System 35