Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 125
Installing a SAS Backplane, Align the installation alignment slot on the bottom of the backplane
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Figure 3-31. Removing and Installing a 3.5" Drive SAS Backplane 3 2 1 4 5 1 retention pin 3 control-panel cable connector 5 installation alignment slot 2 SAS backplane 4 retention slots (7) Installing a SAS Backplane 1 Install the SAS backplane: a Slowly lower the backplane into the system, being careful to avoid damaging components on the face of the board. b Align the installation alignment slot on the bottom of the backplane with the alignment pin on the bottom of the chassis. See Figure 3-31. Installing System Components 125
Installing System Components
125
Figure 3-31.
Removing and Installing a 3.5" Drive SAS Backplane
Installing a SAS Backplane
1
Install the SAS backplane:
a
Slowly lower the backplane into the system, being careful to avoid
damaging components on the face of the board.
b
Align the installation alignment slot on the bottom of the backplane
with the alignment pin on the bottom of the chassis. See Figure 3-31.
1
retention pin
2
SAS backplane
3
control-panel cable connector
4
retention slots (7)
5
installation alignment slot
5
4
3
1
2