Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 33
System Messages, The sensor returns to a normal state but fails again, resulting in a new - memory configuration
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Any of these actions will remove fault messages, and return the status indicators and LCD colors to the normal state. Messages will reappear under the following conditions: • The sensor returns to a normal state but fails again, resulting in a new SEL entry. • The system is reset and new error events are detected. • A failure is recorded from another source that maps to the same display entry. System Messages System messages appear on the screen to notify you of a possible problem with the system. Table 1-8 lists the system messages that can occur and the probable cause and corrective action for each message. NOTE: If you receive a system message that is not listed in Table 1-8, check the documentation for the application that is running when the message appears or the operating system's documentation for an explanation of the message and recommended action. CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. Table 1-8. System Messages Message Causes Corrective Actions Alert! Node The memory Ensure that the memory Interleaving configuration does not modules are installed in a disabled! Memory support node configuration that supports configuration does interleaving. The system node interleaving. See not support Node will run but with reduced "General Memory Module Interleaving. functionality. Installation Guidelines" on page 92. If the problem persists, see "Troubleshooting System Memory" on page 156. About Your System 33