Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 81
Removing the Riser Board, Remove the PEM. See Removing the PEM or PEM Shell
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Figure 3-12. Riser Boards 1 2 1 4-processor riser board 2 2-processor riser board Removing the Riser Board CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 65. 3 Remove the PEM. See "Removing the PEM or PEM Shell" on page 73. 4 To remove the riser board, lift both riser retention latches until the riser is released from its socket, then lift the riser board from the chassis. See Figure 3-13. Installing System Components 81