Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 87
Insert the TOE/iSCSI key into the connector onto the board. See
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
NOTE: When future NIC functionality is supported, you must replace the original TOE/iSCSI hardware key with a new hardware key. 1 Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet. 2 Open the system. See "Opening the System" on page 65. 3 Locate the TOE/iSCSI key connector on the system board (see Figure 6-1). If you have an expansion card installed in slot 7, you may have to remove the card. See "Removing an Expansion Card" on page 80. 4 Insert the TOE/iSCSI key into the connector onto the board. See Figure 3-16. Figure 3-16. Installing a TOE/iSCSI Key 1 2 1 TOE/iSCSI key 2 TOE/iSCSI key connector 5 If applicable, reinstall the expansion card in slot 7. See "Installing an Expansion Card" on page 78. 6 Close the system. See "Opening the System" on page 65. 7 Reconnect the system to power and restart the system. Installing System Components 87