Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 72
Replacing a Power Supply, Close the release lever until the power supply is fully seated and the lever
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Figure 3-6. Removing and Replacing a Power Supply 1 2 3 1 power supply 3 lever release latch 2 release lever Replacing a Power Supply 1 Holding the lever in the open position, slide the new power supply into the chassis until the lever contacts the system chassis. See Figure 3-6. 2 Close the release lever until the power supply is fully seated and the lever snaps into place behind the lever release latch. See Figure 3-6. NOTE: If you unlatched the cable management arm in step 2 of the previous procedure, relatch it. For information about the cable management arm, see the system's Rack Installation Guide. 3 Connect the power cable to the power supply and plug the cable into a power outlet. NOTICE: When connecting the power cable, insert the cable through the strainrelief loop. 72 Installing System Components