Dell PowerEdge R905 Hardware Owner's Manual (PDF) - Page 79
connector aligns with the expansion-card connector on the system
View all Dell PowerEdge R905 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
6 Install the expansion card: a Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion-card connector on the system board. NOTICE: If you are installing a SAS RAID controller card, do not press on the memory module when installing the card. b Insert the card-edge connector firmly into the expansion-card connector until the card is fully seated. c Close the expansion-card retainer. See Figure 3-11. Figure 3-11. Installing or Removing an Expansion Card 2 1 1 expansion card 3 card-edge connector 3 2 expansion-card retainer Installing System Components 79
Installing System Components
79
6
Install the expansion card:
a
Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector on the system
board.
NOTICE:
If you are installing a SAS RAID controller card, do not press on the
memory module when installing the card.
b
Insert the card-edge connector firmly into the expansion-card
connector until the card is fully seated.
c
Close the expansion-card retainer. See Figure 3-11.
Figure 3-11.
Installing or Removing an Expansion Card
1
expansion card
2
expansion-card retainer
3
card-edge connector
3
2
1