HP xw8600 HP xw8600 Workstation Service and Technical Reference Guide - Page 68
Replacing the side access panel, Hood Sensor (Smart Cover Sensor) (optional), Removing the Hood Sensor
View all HP xw8600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
3. Pull up on the handle and rotate the cover off the chassis as shown in the following figure. Figure 4-6 Removing the access panel Replacing the side access panel To replace the side access panel: 1. Align the bottom groove of the side panel with the bottom edge of the chassis. 2. Rotate the side panel toward the chassis and press firmly until the latch engages. Hood Sensor (Smart Cover Sensor) (optional) This section describes how to remove the Hood Sensor. Removing the Hood Sensor To remove the Hood Sensor: 1. Disconnect power from the system (see Predisassembly procedures on page 52). 2. Remove the side access panel (see Removing the side access panel on page 57). 3. Disconnect the hood sensor connector from the inline connector attached to the front panel harness. 58 Chapter 4 Removal and replacement procedures ENWW