HP xw8600 HP xw8600 Workstation Service and Technical Reference Guide - Page 70
Removing the front bezel, Bezel blanks, Removing bezel blanks
View all HP xw8600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Removing the front bezel To remove the front bezel: 1. Lift the three release snaps located on the front bezel (1) as shown in the following figure. Figure 4-8 Removing the front bezel 2. Rotate the front bezel away from the chassis to remove the bezel (2). Replacing the front bezel To replace the front bezel, align the bezel hooks with the chassis holes, and then rotate in until it snaps into place. Bezel blanks This section describes how to remove bezel blanks Removing bezel blanks To remove bezel blanks: 1. Disconnect power from the system (see Predisassembly procedures on page 52). 2. Remove the front bezel (see Removing the front bezel on page 60). 60 Chapter 4 Removal and replacement procedures ENWW
Removing the front bezel
To remove the front bezel:
1.
Lift the three release snaps located on the front bezel (1) as shown in the following figure.
Figure 4-8
Removing the front bezel
2.
Rotate the front bezel away from the chassis to remove the bezel (2).
Replacing the front bezel
To replace the front bezel, align the bezel hooks with the chassis holes, and then rotate in until it snaps
into place.
Bezel blanks
This section describes how to remove bezel blanks
Removing bezel blanks
To remove bezel blanks:
1.
Disconnect power from the system (see
Predisassembly procedures
on page
52
).
2.
Remove the front bezel (see
Removing the front bezel
on page
60
).
60
Chapter 4
Removal and replacement procedures
ENWW