HP xw8600 HP xw8600 Workstation Service and Technical Reference Guide - Page 71
Front panel I/O device assembly
View all HP xw8600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
3. Gently squeeze in on the tabs (1), and push the bezel blanks out of the front bezel (2) as shown in the following figure. Figure 4-9 Removing the bezel blanks A bezel blank has a hook on both sides. It is symmetric and can be installed upside down without issue. To replace a blank, align its hook on one side with the slot in the bezel, then rotate it until it snaps into place. Front panel I/O device assembly This section describes how to remove and install a front panel I/O device assembly. Removing the front panel I/O device assembly To remove the front panel I/O device assembly: 1. Disconnect power from the system (see Predisassembly procedures on page 52 ). 2. Remove the side access panel (see Removing the side access panel on page 57). 3. Remove the front bezel (see Removing the front bezel on page 60). ENWW Removing and replacing components 61