HP xw8600 HP xw8600 Workstation Service and Technical Reference Guide - Page 74
Optical drive,
View all HP xw8600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
5. Disconnect the power button assembly cable from the system board as shown in the following figure. Figure 4-13 Removing the power button assembly cable 6. Disconnect the speaker wire and the hood sensor from the in-line connectors on the power button assembly cable. 7. Remove the screw that secures the power button assembly to the chassis (1) as shown in the following figure. Figure 4-14 Removing the power button assembly 8. Pull the power button assembly away from the front of the chassis, and then rotate the assembly out from the front of the chassis (2). To replace the power button assembly, reverse the previous steps. Optical drive This section describes how to remove and install an optical disk drive. 64 Chapter 4 Removal and replacement procedures ENWW